CaCl₂Drag to rotate
3D ball-and-stick modelCaCl
Industrial chemicals

Calcium Chloride (CaCl₂)

Flakes 74–77 % / prills 94–97 %

CAS 10043-52-4HS 2827.20
Product family
Chemicals
Forms
FlakesPearls / prillsPowderLiquid 30–38 %
Packaging
25 kg bags1–1.5 t big bags
Request TDS / MSDS

What is calcium chloride?

Calcium chloride (CaCl₂) is a highly soluble, strongly hygroscopic salt (CAS 10043-52-4 anhydrous, 10035-04-8 dihydrate). It is sold mainly as calcium chloride flakes 74–77 %, which are the dihydrate, and as anhydrous calcium chloride prills or granules 94–97 %.

It dissolves with heat, pulls water from air and lowers the freezing point of water far more than common salt. These properties make it useful from oilfield brines to winter road maintenance.

Where is calcium chloride used?

In oil and gas, CaCl₂ makes heavy clear brines for completion and workover and the water phase of oil-based mud. It is also used for de-icing and dust control on roads, as a set accelerator in concrete, as a firming agent in food processing, in refrigeration brines and as a drying agent.

How is calcium chloride produced?

Calcium chloride comes from three sources: as a co-product of the Solvay (ammonia-soda) process for soda ash, from natural underground brines, and by reacting limestone with hydrochloric acid. The purified liquor is then concentrated.

  • Flakes 74–77 %: concentrated liquor is cooled on a rotating drum and solidifies as the dihydrate.
  • Prills, granules and powder 94–97 %: the material is dried further, usually in a fluid-bed or spray dryer, to remove almost all water of crystallisation.
  • Liquid 30–40 %: the purified liquor itself, mainly sold close to the plant.

Calcium chloride grades and forms

The form decides how much CaCl₂ you buy per tonne and how much heat is released on dissolving. The table compares the forms; each is then explained with its typical uses.

Flakes 74–77 %Prills / granules 94–97 %Food grade (E509)
Chemical formDihydrateAnhydrousEither
CaCl₂ per tonne≈ 750 kg≈ 950 kgAs specified
Heat on dissolvingModerateHighDepends on form
Best forBrines, de-icing, dust controlHeavy brines, OBM, remote sitesCheese, canning, beverages

Calcium chloride flakes 74–77 %

The most widely traded form and the lowest cost per tonne of product. Flakes dissolve quickly and give a moderate temperature rise, which makes brine mixing at the rig or depot easier.

Typical uses
  • Completion and workover brines
  • Road de-icing and dust control
  • Concrete set acceleration
  • Refrigeration brines

Anhydrous prills and granules 94–97 %

About 25 % more CaCl₂ per tonne than flakes, so freight per unit of active salt is lower. They release more heat on dissolving and are very hygroscopic, so packaging must stay sealed.

Typical uses
  • Oil-based mud water phase
  • High-density brines
  • Desiccant and drying agent
  • Remote sites where freight is costly

Food grade (E509)

Purified calcium chloride that meets food-additive limits for heavy metals, fluoride and magnesium.

Typical uses
  • Cheese making
  • Firming of canned vegetables and fruit
  • Brewing water and beverages
  • Electrolyte drinks

Typical analysis

ParameterFlakes 74–77 %Prills 94–97 %Food grade
CaCl₂74.0–77.0 %94.0–97.0 %≥ 94 % (anhydrous)
Alkali chlorides (as NaCl)≤ 5.0 %≤ 3.0 %≤ 2.0 %
MgCl₂≤ 0.5 %≤ 0.5 %≤ 0.2 %
Water-insoluble matter≤ 0.2 %≤ 0.2 %≤ 0.1 %
Fe≤ 0.005 %≤ 0.005 %≤ 0.002 %
pH (10 % solution)7.5–11.07.5–11.07.0–10.0

Typical values are a guide. The binding specification is the one in our offer and in the Certificate of Analysis for each lot.

Physical properties

PropertyFlakes (dihydrate)Prills (anhydrous)
AppearanceWhite flakesWhite prills, granules or powder
Molar mass147.0 g/mol111.0 g/mol
Densityabout 1.85 g/cm³about 2.15 g/cm³
Bulk densityabout 0.8–0.95 t/m³about 0.9–1.1 t/m³
Melting pointloses water from about 175 °C772 °C
Solubility in watervery highabout 745 g/L at 20 °C
Max. brine densityabout 1.39–1.40 SG (11.6 ppg)same brine

Chemical properties

Calcium chloride is a neutral to slightly alkaline salt. Full data is on PubChem.

  • Deliquescent: absorbs moisture from air until it dissolves.
  • Dissolving releases heat, strongly for the anhydrous form.
  • A 30 % solution freezes only at about −50 °C, far lower than salt brine.
  • Precipitates calcium carbonate or sulfate with carbonate or sulfate ions.
  • Chloride solutions corrode carbon steel; inhibitors are used in brines.

Calcium chloride uses

Completion and workover brines

CaCl₂ brine reaches about 1.39–1.40 SG, heavier than KCl brine, without solids that could damage the reservoir.

Oil-based mud

A 20–35 % CaCl₂ brine is the internal phase of oil-based mud; its water activity is set to match the shale and prevent hydration.

De-icing and dust control

It melts ice at much lower temperatures than rock salt and keeps unpaved roads damp and dust-free.

Concrete

Small additions accelerate setting in cold weather, within chloride limits set by concrete standards.

Food and beverages

Food-grade CaCl₂ helps milk coagulate in cheese making and keeps canned vegetables firm.

Main calcium chloride supplier countries

China is the largest producer and exporter, mainly from Solvay soda ash plants. The United States produces from natural brines, and Europe, Russia and Israel are also important sources.

Calcium chloride in Turkey

In Turkey, calcium chloride is used for road de-icing, construction, food and oilfield work, and supply comes from both local and imported material, mainly flakes and prills. Istanbul is a convenient point to combine it with other drilling chemicals.

Mercafons supplies flakes and anhydrous prills, with grade, NaCl and insolubles confirmed on the CoA before shipment.

Calcium chloride price per ton

The calcium chloride price depends mainly on form: prills cost more per tonne than flakes but contain more CaCl₂. Compare offers per tonne of 100 % CaCl₂. Request a quote with form, quantity and destination.

Calcium chloride packaging

Because calcium chloride absorbs water, all bags have a sealed PE layer. Pallets are shrink-wrapped and labelled with product, form, lot and net weight.

25 kg bags – Calcium Chloride (CaCl₂) packaging | Mercafons
25 kg bagsPE or woven PP bags with sealed PE liner; 40–48 bags per pallet.
1–1.5 t big bags – Calcium Chloride (CaCl₂) packaging | Mercafons
1–1.5 t big bags1 t FIBC with PE liner for brine plants.

Shipment

Calcium chloride is not a dangerous good for transport. A 20 ft container usually takes 24–27 t of bagged product, subject to road weight limits. See logistics. HS code: 2827.20.

Storage and safety

Storage

Keep bags sealed in a dry, covered store; opened bags turn wet and solid. Use part bags quickly and reseal them.

Safety

Calcium chloride causes serious eye irritation (GHS H319). Wear goggles and gloves. Add prills to water gradually, because dissolving can heat the solution strongly.

Calcium chloride FAQ

What is the difference between flakes and prills?

Flakes are the dihydrate with about 75 % CaCl₂; prills are anhydrous with about 95 %. Prills carry more salt per tonne and release more heat when dissolved.

How heavy can a calcium chloride brine be?

About 1.39–1.40 SG (11.6 ppg) at room temperature. Heavier brines use calcium bromide or zinc bromide.

Why is CaCl₂ used in oil-based mud?

The brine phase controls water activity, so water does not move into the shale. Our engineers can help set the salinity.

To what temperature does it melt ice?

It works down to about −30 °C in practice, much colder than rock salt.

Is calcium chloride hazardous?

It is an eye irritant but not a dangerous good for transport. Normal PPE is enough for handling.

Calcium chloride documents: MSDS, TDS and CoA by form

The dihydrate and the anhydrous salt have different CAS numbers and dissolving behaviour, so each has its own SDS. See technical documents.

Last reviewed: November 2026